3rd edition Attribute measurement System Study
- January 9, 2004 at 1:21 pm #34252
DillonParticipant@Doug Include @Doug in your post and this person will
be notified via email.
We have many, many attribute gages that measure several demensions (e.g. length, angle, wideth, shape, etc.) As I understand the requirements of the MSA standard, to run the attribute study we need “known” samples that range for below specification, through the spec, to over specification. Because of the many variables measured by our gages I do not know how to produce the required samples. Does anyone else have this situation? How can I address this and still meet the requirements of the standard? My QS 9000 registrar is insisting on it!!!Any help is greatly appreciated.0January 9, 2004 at 3:30 pm #94112
The forum ‘General’ is closed to new topics and replies.