iSixSigma

creating response surface design in minitab

Six Sigma – iSixSigma Forums Old Forums General creating response surface design in minitab

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #50892

    Fontanilla
    Participant

    Hi, I’m completely new to using Minitab so any help will be greatly appreciated.I conducted an experiment that had two factors which both affected one outcome/response. I’m trying to create a ‘response surface design’ and then make a contour plot from this. However after entering in the two factors, when I go through and create the design, the outcome/response does not show up in the new worksheet, preventing me from using the ‘analyze response surface design’. Can anyone give any guidance to this?Thanks,
    Dan

    0
    #175532

    Bower Chiel
    Participant

    Hi Dan
    I’d be happy to try and help if you could give me sight of your data via [email protected].
    Best Wishes
    Bower Chiel

    0
    #175537

    Darth
    Participant

    If I am interpreting your question correctly, you said that you created the design matrix but that no response column showed up in the worksheet. Big DUH on this one. Using the treatment runs specified in the design matrix, YOU now run your experiment and enter the resulting response in another column. Then you can analyze the data. Minitab won’t produce the response or outcome, you have to run the experiment and record the results.

    0
Viewing 3 posts - 1 through 3 (of 3 total)

The forum ‘General’ is closed to new topics and replies.