iSixSigma

Gauge R&R on Laser Gauge

Six Sigma – iSixSigma Forums General Forums Tools & Templates Gauge R&R on Laser Gauge

This topic contains 1 reply, has 2 voices, and was last updated by  Mike Carnell 3 months, 2 weeks ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #236076

    Jacque Bickley
    Participant

    I am working on implementing ISO17025 in our facility. I need to complete a Gauge R&R on a 0-1″ laser micrometer that we manufacture. I want to use the XX pin set and do measurements the entire length of the gauge tolerance. Would I use the same method as if we manufactured a part and used its tolerance but instead use the XX tolerance class.

    0
    #236082

    Mike Carnell
    Participant

    @jacquebickley Using pin gages as a substitute for parts is fine. What you might consider doing is using multiple micrometers and treat them as if they were operators and only use 1 operator. Theoretically the micrometers should all be the same? If that works your reproducibility number is the difference you see from using one micrometer to another.

    Just a thought.

    0
Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.