iSixSigma

Hard Time Commenting on Older Posts?

Six Sigma – iSixSigma Forums General Forums General Hard Time Commenting on Older Posts?

This topic contains 7 replies, has 4 voices, and was last updated by  Craig Setter 8 months, 1 week ago.

Viewing 8 posts - 1 through 8 (of 8 total)
  • Author
    Posts
  • #55970

    Craig Setter
    Participant

    Hello, I was trying to comment on a forum post from 2015, but the system will not let me. Does anybody know what might be the problem?

    Thanks!

    Craig

    #202453

    Robert Butler
    Participant

    A lot of the posts are locked and will say so at the very bottom. Frankly, given a time lag of 3 years it would probably be better to start a new thread. The started locking several years ago because people were not paying attention to the original thread date and were doing things like asking for information from the original poster who had long since quit visiting the site.

    #202454

    Katie Barry
    Keymaster

    @csetter If you could point out the specific post you’re trying to reply to I’d be happy to take a look. As @rbutler stated, the thread may be closed. Or it might be an error.

    #202455

    Chris Seider
    Participant

    @KatieBarry on the job always! :)

    #202456

    Katie Barry

    @cseider It’s a dirty job, but somebody’s gotta do it.

    #202457

    Craig Setter
    Participant

    Hi Katie,

    Thank you so much for your response (and everyone else as well). I am trying to post at https://www.isixsigma.com/topic/the-council-for-six-sigma-certification/. Although it is a few years old, recent court records make it extremely likely that the comments were posted with malicious intent by another training provider/accrediting agency (most comments were made anonymously or with only a post history of “1”). So I just wanted to provide readers with the “smoking gun” so they could practice their own due diligence.

    I could start a new thread, but it would likely make the issue more complicated to the reader.

    Any assistance you could provide would be greatly appreciated.

    Thank you and have a wonderful day,

    Craig

    #202461

    Katie Barry
    Keymaster

    @csetter The thread remains open so I don’t know why you weren’t able to submit your response initially. If you try again and still run into problems, please contact me at editor (at) isixsigma (dot) com with the specifics of what happens (e.g., are you getting an error message? what does it say?).

    #202463

    Craig Setter
    Participant

    Thank you Katie, it suddenly worked for me! Thanks so much (and everyone else as well) for your time. Have a great day everyone :)

Viewing 8 posts - 1 through 8 (of 8 total)

You must be logged in to reply to this topic.