poka-yokes

This topic has 1 reply, 2 voices, and was last updated 19 years, 4 months ago by Chip Hewette.

Viewing 2 posts - 1 through 2 (of 2 total)

Author

Posts
January 23, 2003 at 8:17 pm #31311

mcleod
★ 10 Years ★
Member

@scott Include @scott in your post and this person will
be notified via email.

Has anyone out there poka-yoked a CAD system? I’m thinking about various prompts which guide user and lessen ability to make mistakes on, or submit incomplete drawings. Any/all comments appreciated.

thx

0

January 23, 2003 at 9:00 pm #82397

Chip Hewette
★ 10 Years ★
Participant

@Chip-Hewette Include @Chip-Hewette in your post and this person will
be notified via email.

I hope you can succeed!
Have you followed DMAIC in this project? Poka-yokes are great, but have you identified the issues at hand? Pardon me if you’ve already considered the following…
Missing dimensions are often found when the drawing reaches the fabrication shop. Who are other customers of the drawing? What do they complain about?
Be careful not to listen to everyone who says “This error happens all the time.” Most humans are very good at noticing a “pet” error but also very good at ignoring other errors.
Collect data!
Since you have ONE drawing with multiple potential errors, be sure to use the correct distribution to study the data.

0
Author

Posts

Viewing 2 posts - 1 through 2 (of 2 total)

The forum ‘General’ is closed to new topics and replies.