SPC software
Six Sigma – iSixSigma › Forums › Old Forums › General › SPC software
- This topic has 1 reply, 2 voices, and was last updated 13 years, 8 months ago by
Craig.
Viewing 2 posts - 1 through 2 (of 2 total)
-
AuthorPosts
-
September 15, 2008 at 9:52 am #50938
DarioEstebanParticipant@DarioEstebanInclude @DarioEsteban in your post and this person will
be notified via email.Hello colleges,
In our pharmaceutical plant, we are going to pass from paper to PC in the SPC policy. Which software whould you recommend in terms of? :
– Easy to use
– FDA compliance
– Analytical posibilities
– Reliability
– ROI
I’ve see several programs (Sinergy 2000, Measurlink …) but I would like some experienced opinion from the hands on use.
Thank you very much0September 15, 2008 at 10:16 am #175757if you need a network based system where data can be collected automatically from metrology equip, try WinSPC.
manual data entry is also possible. this tool has many off-line analysis tools as well, and very good report generation capabilities.
0 -
AuthorPosts
Viewing 2 posts - 1 through 2 (of 2 total)
The forum ‘General’ is closed to new topics and replies.